How to remove Comio C1 FRP

Updated on September 20, 2018

These are the instructions to remove or bypass the Comio C1 FRP protection using the SP Flash Tool on Windows Computer.

Requirements: Your device needs to have at-least 30-40 percent of battery to perform the flashing process.

Remove Comio C1 FRP using SP Flash Tool

Step 1: Download and install CDC Driver on your Computer. If in case CDC or VCOM drivers are already installed on your computer then SKIP this step.

usb logo

Step 2: Power Off your Device.

Power Off Comio C1 FRP

Step 3: Download and Extract the Comio C1 FRP Remove File on your computer. After Extracting the Comio C1 FRP File, you will be able to see the following files:

comio c1 frp

Step 4: Download and Extract the latest version of SP Flash Tool on your Computer. After Extracting the SP Flash Tool on your Computer, you will be able to see the following files:

Smart Phone Flash Tool Extracted Files

Step 5: Now, Open Flash_Tool.exe.

Open SP Flash Tool

Step 6: Once SP Flash Tool is Launched, Click on the Download Tab to Proceed.

SP Flash Tool Download Tab

Step 7: Now, Click on the Download Agent Choose button and Select the Comio_C1_DA.bin (found in the FRP Files Folder).

sp flash tool download agent

sp flash tool download agent comio c1

Step 8: Now, Click on the Scatter Loading Button and Load the Comio C1 Scatter File (found in the extracted file in Step#3).

sp flash tool comio c1 scatter

comio c1 frp scatter

Step 9: Now, Click on the Format Menu.

comio c1 sp flash tool format menu

Step 10: Under Format Menu, select Manual Format Flash.

sp flash tool manual format flash

Step 11: Now, Set the Following parameters: Region: EMMC_USER, Begin Address[HEX]: 0x6a00000, Format Length[HEX]: 0x100000.

manual format parameter

Step 12: Now, Click on the Start Button:

manual format start

Step 13: Now, Connect your Device to the Computer using the USB Cable (make sure device is Power Off). After connecting the device to the computer, Press Volume Down and Up Keys on your Smartphone to get it detected by the SP Flash Tool.

mobile usb computer

Step 14: Once SP Flash Tool is able to detect the device, flashing process will start automatically and May take upto 5 minutes to get it completed.

Step 15: Once Flashing process is completed, you will be able to see the Green Tick at the End.

Green Ring SP Flash Tool

Step 16: Now, Close the SP Flash Tool and Disconnect your device from the computer.

Step 17: Restart your device.

Readme Once:

[*] Why Flashing is Not Starting: Flashing process will only begin if you have successfully installed the Android CDC Driver or Android VCOM Driver on your computer. And If in case Drivers are already installed, you need to press the Volume keys after connecting the device to the computer.

[*] Alternative Tool: SP Multiport Download Tool is the alternative Flash Tool which can also be used for Flashing the Scatter File. But we always recommend you to use SP Flash Tool against SP Multiport Download Tool.

[*] Credits: The FRP file shared above is submitted by our reader Gsm Abdullah. So, full credits goes to him for sharing the File for free.

Comments
Designed by Five Alphabets | Hosted on BlueHost

Copyright © 2013-2018 Android MTK. All Rights Reserved.