These are instructions on how to remove or bypass FRP Lock on Tecno Pop 3 BB2 Smartphone using the SP Flash Tool.

Caution: Removing or bypassing the FRP protection using the SP Flash Tool may wipe/delete the device’s data. Therefore, we aren’t responsible for any data loss on the device.

Bypass Tecno Pop 3 BB2 FRP Lock using SP Flash Tool

  1. Download and install MediaTek Drivers on the Computer. If in case Mediatek Drivers are already installed on the computer, then SKIP this step.
    2. USB Logo
  2. Download and Extract the Tecno Pop 3 BB2 FRP package on the computer. After Extracting the Tecno Pop 3 BB2 FRP package, you will be able to see the following files:
    3. Tecno Pop 3 BB2 FRP Files
  3. Download and Extract the SP Flash Tool (latest) on the Computer. After Extracting the SP Flash Tool, you will get following files:
    4. SP Flash Tool Extracted Files
  4. Open Flash_Tool.exe.
    5. Open SP Flash Tool
  5. Once SP Flash Tool is Launched, Click on the Scatter Loading Button and Load the Tecno Pop 3 BB2 Scatter File (found in the extracted file in Step#2).
    6. SP Flash Tool Scatter Loading Tecno Pop 3 BB2 Scatter Select
  6. Click on the Format Menu.
    7. Tecno Pop 3 BB2 SP Flash Tool Format Menu
  7. Under Format Menu, select Manual Format Flash.
    8. SP Flash Tool MT6580 Manual Format Flash
  8. Set the Following parameters: Region: EMMC_USER, Begin Address[HEX]: 0xa040000, Format Length[HEX]: 0x100000.
    9. MT6768 0x3188000 0x100000 Manual Format Parameter
  9. Click on the Start Button:
    10. MT6768 0x3188000 0x100000 Manual Format Parameter Start
  10. Connect your device to the computer using the USB cable (make sure the device is Power Off). After connecting the device to the computer, Press Volume Down and Up Keys on your Smartphone to get it detected by the SP Flash Tool.
    11. Mobile USB Computer
  11. Once SP Flash Tool detects the device, the flashing process will start automatically and may take up to 5 minutes to complete. Once the Flashing process is completed, you will be able to see the Green Tick at the End.
    12. MT6768 0x3188000 0x100000 Success
  12. Now, Close the SP Flash Tool and disconnect your device from the computer.
    13. Disconnect Mobile Computer

    Congratulations! Now, Restart the Device, and you won’t be facing the FRP protection on the device.

Notes

[*] Caution: Removing the FRP (factory reset protection) from the Tecno Device will wipe the data. Therefore, we recommend you take a backup of your data before following the tutorial above.

[*] Alternative Tool: SP Multiport Download Tool is the alternative Flash Tool which can be used to flash or install the Scatter Firmware.

[*] Tecno Stock Firmware: If you are looking for the original firmware for your device, then head over to Download Tecno Stock Firmware page.

[*] Tecno USB Driver: If you are looking for the original USB Driver for your device, then head over to Download Tecno USB Driver page.

[*] Credits: Mohnish Pal submits the FRP file shared above. So, full credit goes to him for sharing the File for free.